Furman Sound PL-PRO D II User Manual download pdf (Page 4)

SERIES II 20 AMP POWER CONDITIONERS

carefully before using.

WA R N I N G

To reduce the risk of electrical shock, do not

expose this equipment to rain or moisture.

Dangerous high voltages are present inside the

enclosure. Do not remove the covers. Refer

servicing to qualied personnel only. The

lightning ash with an arrowhead symbol, is

intended to alert the user to the presence of

un-insulated dangerous voltage within the

product’s enclosure that may be of sufcient

magnitude to constitute a risk of electric shock.

I M P O R TA N T S A F E T Y

I N S T R U C T I O N S

(Please read prior to installation)

1. Please read and observe all safety and

operating instructions before installing your

Series II unit. Retain these instructions for

future reference.

2. Your Series II unit should not be used near

water – for example, near a bathtub, washbowl,

kitchen sink, laundry tub, in a wet basement,

near a swimming pool, etc.

3. Do not place your Series II unit near heat

sources such as radiators, heat registers,

stoves, or other appliances that produce heat.

4. The PL-PRO II, PL-PRO D II, and PM-PRO

II should only be connected to a 120 VAC,

60Hz, 20 amp grounded electrical outlet. Do

not defeat the ground or change polarization of

the power plug. (E versions 220 – 240 VAC 50 Hz., J

versions 100 – 120 VAC 50 Hz.)

5. Route the power cord and other cables so

that they are not likely to be walked on, tripped

over, or stressed. Pay particular attention

to the condition of the cords and cables at

the plugs, and the point where they exit your

Series II unit. To prevent risk of re or injury,

damaged cords and cables should be replaced

immediately.

6. Clean your Series II unit with a damp cloth

only. Do not use solvents or abrasive cleaners.

Never pour liquid on or into the unit.

7. Your Series II unit should be serviced by

qualied service personnel when:

• The power supply cord or the plug has been

frayed, kinked, or cut.

• Objects have fallen or liquid has spilled into

the unit.

• The unit has been exposed to rain or other

moisture.

• The unit does not appear to operate normally.

• The “Protection OK” indicator is not lit.

• The unit has been dropped, or the enclosure

has been damaged.

• The retractable LED lights have failed. (not

applicable to the PM-PRO II)

8. Your Series II unit requires that a safety

ground be present for proper operation. Any

attempt to operate the unit without a safety

ground is considered improper operation and

could invalidate the warranty.

3

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments